COMBO SET BUILDER
Each set pairs our heavy fleece hoodie with matching sweatpants. Treated with individual acid wash baths and finished with hand distressing for $100 flat.
Care & Sizing Specs
Essential care protocols to maintain acid wash depth and raw hand-distressed detailing, accompanied by exact sizing measurements for the $100 hoodie and sweat combo.
480 GSM French Loopback Cotton Terry
Dense, custom-knitted loopback fleece engineered for slouchy boxy volume without sagging.
Sulfur Mineral Immersion Batch 04
Single-vat mineral wash resulting in high-contrast gray marbling where no two pieces are identical.
Engineered Drop Shoulder + Stacked Leg
Relaxed torso with slightly cropped hem; sweatpants feature elongated rise and stacked ankle cuffs.
Individual Artifact Variation
Due to the intense acid washing and individual manual distressing passes, variances in saturation, abrasion depth, and edge fraying are expected and intentional.
Cold Wash Only (30°C / 85°F)
Turn the hoodie and sweatpants inside-out prior to loading. Wash in cold water on a delicate or gentle cycle to safeguard hand-abrasion edges and maintain the tonal acid wash balance.
Note: Never use chlorinated bleach or harsh stain dissolvers.
Preserve Hand-Frayed Details
Each distress mark is individually carved before garment dyeing. Avoid washing with garments that feature exposed zippers, metal studs, or open velcro which could pull loose fiber fringes.
Note: Fraying will naturally soften with every cycle into a signature patina.
Flat Dry or Low-Tumble Steam
Lay flat on an drying rack to preserve the heavyweight 480 GSM fleece drape. If machine drying, select ultra-low tumble heat for no longer than 15 minutes, removing while still slightly damp.
Note: High machine heat causes fleece tension pull and shrinkage.
Steaming & Ironing Protocol
Use a handheld garment steamer from the reverse side of the fabric. If using a standard iron, set temperature to synthetic-cotton blend and avoid direct contact with graphic hits or raw pocket tears.
Note: Do not press hot iron faces directly into high-abrasion zones.